Dual mode dual fuel combustionimplementation on a real medium duty engine platform

Resumo

The medium and heavy-duty transport sector was historically challenged by the emissions regulations that were imposed along the years, requiring to step up the research effort aiming at advancing the product development to deliver a normative compliant option at similar price to the owner. Nonetheless, the recent introduction of EUVI normative have required the addition of a complex aftertreatment system, adding new fixed costs to the product as well as operational costs with the urea consumption. This breakthrough was required due to the limitation of the conventional diesel combustion which cannot decouple high NOx emissions and efficiency. This technological limitation has boosted the investigation on different combustion concepts that could maintain similar efficiency levels than the diesel combustion while controlling the emission formation during the combustion process. Among the different solutions that have appeared along the years, Reactivity Controlled Compression Ignition (RCCI) was demonstrated to have a competitive edge due to its better controllability, high efficiency and low soot and NOx emissions. Despite the benefits, the extension of RCCI to full map operation has presented significant limitations, as excessive pressure gradients at high load and high combustion instability and unburned products at low engine load. Recently, Dual-Mode Dual-Fuel (DMDF) combustion concept was introduced as an attempt of solving the drawbacks of the RCCI combustion while maintaining its advantages. The preliminary results obtained in single cylinder engine (SCE) have evidenced that DMDF can achieves similar efficiency levels than those from conventional diesel combustion while promoting ultra-low levels of soot and NOx. Albeit, the boundary condition requirements are hard to fit in the operating range of commercial air management system as well as drawbacks like excessive HC and CO that still persists from low to medium load, which can be a challenge for the aftertreatment system. Moreover, short-term future regulations will demand a 15 % reduction of CO2 emissions in 2025 which was proven in the literature to not be easily achieved only by combustion process optimization. In this sense, this thesis has as general objective the implementation of the DMDF combustion concept in a multi-cylinder engine (MCE) under the restrictions of real applications to realize clean and efficient combustion in the complete map while providing alternatives to reduce the HC and CO concentration and accomplish CO2 savings. This objective is accomplished by means of a first extensive experimental calibration procedure aiming to translate the guidelines of the DMDF combustion from the SCE to the MCE while respecting the operating limits of the stock hardware, assessing its impacts on combustion, performance, and emission results under steady and driving cycle conditions. Next, dedicated studies are performed to address the issue related with the excessive concentration of unburned products by means of experimental investigations and numerical simulations, to understand the consequences of using fuels with different reactivity in the stock oxidation catalyst conversion efficiency and its ability in achieving EUVI tailpipe emissions. Finally, CO2 reduction is explored through fuel modification, investigating both combustion process improvement and well-to-wheel balance as paths to realize CO2 abatement.